CS DoorLeaveS doors make for a good looking pre-finished alternative to conventional timber finished door leaves. Their robust manufacture allows for over height and width doors to be constructed without fear of product bowing or warping on site. Because they arrive on site pre-finished (even hardware can be pre-fitted) time and money is saved.

The AluMaX can be used in conjunction with the UltimatE Cavity Slider or alternatively, as a surface sliding door.  It is CS For Doors' sturdiest and thickest door (65mm thick) and requires a 120mm stud if it is to be fitted into a cavity pocket.

This type of door suits extreme temperature conditions that would normally cause other doors to bow or warp. Due to its interlocking panel construction that incorporates a negative detail, this is a both a modern and effective door solution.

The AluMaX door is available in standard sizes and can go up to 6 metres high x 6 metres wide, and can come in a natural anodised or powder coated finish.

Buildings and locations where AlumaX SlidinG doors are commonly specified include:

• Banks
• Jewellery stores
• Liquor outlets

CS AluMaX Sliding Door
Features and Benefits:

• Thickness (up to 65mm).
• Unique and modern.
• It will not bow or warp.
• Comes with different finishes, either natural anodised or powdercoated.
• Maintenance free.
• There are no visible screws or fixings.
• Suitable for a variety of environments.
• Can be automated on request.
• Suitable for situations where security is required.